Chassis Context

The 2013 Mercedes-Benz Sprinter NCV3 runs the NCV3 chassis, which launched in the UK in 2006 — a year ahead of North America. Most UK NCV3s carry the 2.1L four-cylinder diesel (OM646 until mid-2009, OM651 after) rather than the OM642 V6 that dominated the US market; badges read 209–519 CDI, with the first digit indicating tonnage and the last two roughly horsepower divided by ten. Euro 6 BlueTEC with AdBlue was optional from 2013 and standard on new registrations from September 2016 — earlier UK NCV3s have no AdBlue system at all. Check recalls at the DVSA vehicle recall service on gov.uk, not NHTSA. The SAM-module and ground-strap guidance familiar from Sprinter forums applies to UK vans exactly as it does elsewhere.

What's Specific to the 2013 Mercedes-Benz Sprinter NCV3

The 2013 UK Sprinter is an OM651 2.1 CDI Euro 5 van — no AdBlue, DPF fitted. Two OM651 items dominate this era: timing-chain stretch (the rear-mounted simplex chain; listen for a cold-start rattle in the first 10–20 seconds and watch for cam/crank correlation codes — worst on pre-2011 builds but reported across the era from around 120,000 km), and the early Delphi piezo injector campaign (2009 to mid-2012, when production switched to solenoid-type injectors). A 2013 with documented injector and chain history is worth meaningfully more than one without. Pre-Euro-6 status means ULEZ/CAZ daily charges apply.

Common Symptoms

DPF Regeneration Problems on the 2013 Mercedes-Benz Sprinter NCV3 typically presents with one or more of these symptoms. The severity, frequency, and diagnostic steps vary significantly by chassis generation, which is why the causes below are written specifically for the NCV3 of the 2013 production year rather than generic "Sprinter" advice.

Likely Causes for the 2013 Mercedes-Benz Sprinter NCV3

For the 2013 model year, the most common root causes involve age-related wear, the specific engineering tolerances of the 2013 production run, and documented chassis issues noted in the chassis context above.

UK duty cycles are the OM651 DPF's biggest enemy: multi-drop urban work and school-run-length trips never let passive regeneration complete. A 2013 showing frequent active regens or a rising soot load needs a regular 20-30 minute steady-load motorway run before it needs parts. Since May 2018, a removed or tampered DPF is a Major MOT failure and the diesel smoke limit was halved for post-2014 vans — DPF removal is not a lawful option in the UK.

What to Do

Start by checking the most common causes listed above. For a step-by-step diagnosis specific to your symptoms, use our free AI Expert chat or the interactive diagnostic tool — both are trained specifically on Sprinter NCV3-based RVs and know the 2013 Mercedes-Benz Sprinter NCV3 inside and out.

🛒 Common parts on Amazon
Search Amazon for 2013 Mercedes-Benz Sprinter NCV3 dpf regeneration problems parts →
As an Amazon Associate, SprinterRVDesk earns from qualifying purchases.

In-Depth Guides

Read our detailed troubleshooting articles on this topic:


Other 2013 Mercedes-Benz Sprinter NCV3 Issues

Owners of the 2013 Mercedes-Benz Sprinter NCV3 also commonly report these problems:

Mercedes-Benz Sprinter NCV3 DPF Regeneration Problems by Year

This issue across other model years: 2010 · 2011 · 2012 · 2014 · 2015 · 2016